I'm using the 4-wire 56K CSU's, rather than the T1's, but otherwise the
same. The T1's give you slightly more options (encoding, timeslots, etc).
I'm also simply using a Cisco rollover cable (same cable you use for Console
port). It works great.
> I doing it with a pair of wic-1dsu-t1. Using a T1 crossover cable that i
> got from pacificcable.com
>
> Neil Schneider
>
>
> ""Tony Mesias"" wrote in message
> [EMAIL PROTECTED]">news:[EMAIL PROTECTED]...
> > Anyone know off the top of thier head if it's possible to configure F-t1
> > interfaces back to back? I have a "cross-over" cable where I hook up
the
> TX
> > from one end to the RX of the other and vice verse, but this is unlike
> High
> > speed serial interfaces where you set a clock rate on one side, drop a
> > couple addresses, throw up HDLC encapsulation and you are off and
running.
> >
> > Any ideas?
> > FAQ, list archives, and subscription info:
> http://www.groupstudy.com/list/cisco.html
> > Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=5153&t=5139
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
