post your configs.
in the abstract what is happening is that the tunnel endpoints are
referencing an address that can only be known via the dynamic routing
protocol. works fine with statics because the static destination is always
"there"
if you do a debug ip routing you will see the reports of what exactly is
happening.
Chuck
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of
Mike
Sent: Tuesday, July 31, 2001 7:03 PM
To: [EMAIL PROTECTED]
Subject: GRE and routing protocols [7:14432]
I've configured a point-to-point GRE tunnel between two routers. Works fine
with static routes, however, once I turn on RIP I get the following in about
30 seconds.
%TUN-5-RECURDOWN: Tunnel0 temporarily disabled due to recursive routing
1d01h: %LINEPROTO-5-UPDOWN: Line protocol on Interface Tunnel0, changed
state to
down
I've read about the recursive routing problem with IP in IP, can someone
explain exactly why this is happening? Also, what is the solution.
thanks,
Mike
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=14440&t=14432
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
