In a message dated 8/13/01 8:33:59 AM Central Daylight Time,
[EMAIL PROTECTED] writes:
Installing Network Processor Modules in the
Cisco 4000 Series
HTH,
Rob H.
I have a Cisco 4000 with 2 serial, 1 token ring and 2 ethernet interface.
However, when a "show interfaces" command is executed, there is only one
ethernet interface shown.
On the back of the router where the ethernet ports are, one is a typical
10baseT, RJ-45 connection, but the other is AUI which I do not have a
transceiver for; I just have a CAT5 cable from the 10baseT connector going
to my switch.
When I do a show interfaces command, ethernet 0 is up, but the protocol is
down. On my swith I do not see any activity lights for that port, so I am
thinking that my e0 is actually the AUI port.
How do I use the 10baseT interface?
--
Vik Evans - MCSE, CCNA, CCDA
[EMAIL PROTECTED]
Cell: (602) 677-8214
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=15865&t=15861
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
