It is only a single port ethernet...
You have a choice of AUI or RJ45..
I do not think the 4000M supports a dual ethernet card..
>===== Original Message From "Vik" =====
>I have a Cisco 4000 with 2 serial, 1 token ring and 2 ethernet interface.
>However, when a "show interfaces" command is executed, there is only one
>ethernet interface shown.
>
>On the back of the router where the ethernet ports are, one is a typical
>10baseT, RJ-45 connection, but the other is AUI which I do not have a
>transceiver for; I just have a CAT5 cable from the 10baseT connector going
>to my switch.
>
>When I do a show interfaces command, ethernet 0 is up, but the protocol is
>down. On my swith I do not see any activity lights for that port, so I am
>thinking that my e0 is actually the AUI port.
>
>How do I use the 10baseT interface?
>
>--
>Vik Evans - MCSE, CCNA, CCDA
>[EMAIL PROTECTED]
>Cell: (602) 677-8214
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=15866&t=15861
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
