Hi
The 4000 and 4000M support the NP-1E and NP-2E, the strange part is that the
NP-1E is not supported on the 4500 or 4700 series...
--
John Hardman CCNP MCSE
""guyman"" wrote in message
[EMAIL PROTECTED]">news:[EMAIL PROTECTED]...
> It is only a single port ethernet...
>
> You have a choice of AUI or RJ45..
>
> I do not think the 4000M supports a dual ethernet card..
>
>
> >===== Original Message From "Vik" =====
> >I have a Cisco 4000 with 2 serial, 1 token ring and 2 ethernet interface.
> >However, when a "show interfaces" command is executed, there is only one
> >ethernet interface shown.
> >
> >On the back of the router where the ethernet ports are, one is a typical
> >10baseT, RJ-45 connection, but the other is AUI which I do not have a
> >transceiver for; I just have a CAT5 cable from the 10baseT connector
going
> >to my switch.
> >
> >When I do a show interfaces command, ethernet 0 is up, but the protocol
is
> >down. On my swith I do not see any activity lights for that port, so I am
> >thinking that my e0 is actually the AUI port.
> >
> >How do I use the 10baseT interface?
> >
> >--
> >Vik Evans - MCSE, CCNA, CCDA
> >[EMAIL PROTECTED]
> >Cell: (602) 677-8214
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=15871&t=15861
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
