I was informed that there is a loop in our interface, and it is not up.
When I do a sh interface, I found it is up but there is a word (looped) as
shown below. What is the meaning??? What happen ?? When I show cdp
neighbor, I see the cdp neighbor of the interface is the router itself??
Why???
sin03>sh int s1/0
Serial1/0 is up, line protocol is up (looped)
sin03>sh cdp nei
Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge
S - Switch, H - Host, I - IGMP, r - Repeater
Device ID Local Intrfce Holdtme Capability Platform Port ID
sin03 Ser 1/0 136 R c3660 Ser 1/0
TYO02 Ser 1/1 154 R 1750 Ser 0
HKG01 Ser 1/2 167 R 1750 Ser 0
SYD02 Ser 2/1 157 R 1750 Ser 0
==================================================================
De informatie opgenomen in dit bericht kan vertrouwelijk zijn en
is uitsluitend bestemd voor de geadresseerde. Indien u dit bericht
onterecht ontvangt wordt u verzocht de inhoud niet te gebruiken en
de afzender direct te informeren door het bericht te retourneren.
==================================================================
The information contained in this message may be confidential
and is intended to be exclusively for the addressee. Should you
receive this message unintentionally, please do not use the contents
herein and notify the sender immediately by return e-mail.
==================================================================
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=18052&t=18052
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]