Not exactly. Do your interfaces show down/down? Do a sh frame-relay pvc
and see if you see your PVC out there. You can also run debug
frame-relay lmi and see if you have the right dlci out there. If you
have term mon on you may see the interface come up and then go back down
when you hook up the line.
You will probably stay in that state until they start taking to you.
regards,
Steve
-----Original Message-----
From: Ole Drews Jensen [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, September 05, 2001 1:16 PM
To: [EMAIL PROTECTED]
Subject: Frame Relay - Behind The Scenes... [7:18653]
I am getting a Frame Relay setup and I just got the local loop installed
and
tested today by the local telco.
I know that the Frame Relay provider hasn't started their configuration
yet,
but shouldn't I be able to see just one little change on my router when
I
connect the CSU/DSU to the local loop box?
I have done a:
show interface serial 0/0
show interface serial 0/0.101
show frame-relay lmi
show controllers serial 0/0
and everything is exactly the same before and after connecting the
cable.
Thanks for any comments on this.
Ole
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Ole Drews Jensen
Systems Network Manager
CCNA, MCSE, MCP+I
RWR Enterprises, Inc.
[EMAIL PROTECTED]
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
http://www.RouterChief.com
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
NEED A JOB ???
http://www.oledrews.com/job
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=18660&t=18653
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
