John, You'll need to specify "encapsulation isl 100" or "encapsulation dot1q 100" depending on what encapsulation type you are using. The 100 is for the vlan #.
Hope this helps. Scot ----- Original Message ----- From: "John Mairs" To: Sent: Thursday, December 27, 2001 12:10 PM Subject: LAN sub-interface routing [7:30225] > Hi, > > I have a 2501 (one ethernet interface) and I wanted to > route over that interface by setting up two > sub-interfaces. I can't assign an address because it > replies with > > "configuring IP routing on a LLAN subinterface is only > allowed if that subinterface is already configured as > part of an IEEE 802.10 or ISL vLAN." > > what will I need to do (specifically if you can) to > route over a single E0 interface? > > thanks > > __________________________________________________ > Do You Yahoo!? > Send your FREE holiday greetings online! > http://greetings.yahoo.com Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=30247&t=30225 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]