I *think* (she says, being too busy/lazy to look up the RFC) that if there is only a single area in an OSPF AS, it does not have to be area 0. As soon as you bung in a second area, though, you need to have one of them as area 0 or the two areas won't be able to talk to each other.
What network is joining Router A and Router B? Going back to the original email... I have 2 routers, Router A and Router B, back to back. Able to get the 2 connected, however when I (Router A) router ospf 20 network 10.1.10.0 0.0.0.0 area 20 (RouterB) router ospf 20 network 192.168.1.0 0.0.0.0 area 20 Is the connection between A and B 10.1.10.0, or 192.168.1.0, or something different? Might be nice to include the connecting network in the OSPF process. Also, your network statements look a bit dodgy. If your networks are /24, try "network 10.1.10.0 0.0.0.255 area 20" and likewise for Router B. Currently you are adding the interface with address 10.1.10.0/32 to the OSPF process, which is presumably not what the address of the interface actually is. I'm surprised it's giving you any errors, because I'm surprised it's doing anything. JMcL ----- Forwarded by Jenny Mcleod/NSO/CSDA on 10/07/2002 03:51 pm ----- "Michael Williams" Sent by: [EMAIL PROTECTED] 10/07/2002 02:36 pm Please respond to "Michael Williams" To: [EMAIL PROTECTED] cc: Subject: RE: OSPF problem [7:48463] Is this part of a business decision process?: Lemme take a stab at this one..... I don't run OSPF where I work, but I'd like to keep my chops up to date =) In OSPF, you need to have an Area 0. If there are 2 routers only in your network, and only one area, it needs to be Area 0. If there is only 1 Area in your network, there is no need for it to be anything other than Area 0. Since every Area must touch Area 0, it seems to me there is something in the IOS that looks for at least one interface to be in Area 0 or at least in a virtual link to Area 0. Change your areas on your routers to Area 0 and see if you have the same problem.... (OSPF gurus, please correct me as, again, I'm just taking a stab and would like to keep my OSPF up to date) (Now that I'm thinking about it, you could have a router that is totally within a certain Area that's not an ASBR or ABR, so not it's possible to there could be an interfaces not in Area 0... so at this point, my whole post is moot..... too many rum and cokes =) OSPF gurus, please advise =) Thanks! Mike W. Important: This e-mail is intended for the use of the addressee and may contain information that is confidential, commercially valuable or subject to legal or parliamentary privilege. If you are not the intended recipient you are notified that any review, re-transmission, disclosure, use or dissemination of this communication is strictly prohibited by several Commonwealth Acts of Parliament. If you have received this communication in error please notify the sender immediately and delete all copies of this transmission together with any attachments. Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=48473&t=48463 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]