Thanks Spio,
I've cleared the counters for "show int" and noticed that the input errors
are showing up on the 7200 and not on the 7500 which might make things a bit
clearer, the counters hadn't been cleared since installation so the 7500
input errors might have been from when it was first brought online. I've
also included the output from the "show controllers" command if you wouldn't
mind having a look for me, although I didn't get much output from the "show
controllers" command on the 7500.
Thanks again for your help!
Mark.
7200
Serial4/0 is up, line protocol is up
Hardware is M1T-T3 pa
Description: NOC01-DS3-MAN01
Internet address is ***.***.***.***/30
MTU 4470 bytes, BW 44210 Kbit, DLY 200 usec,
reliability 255/255, txload 22/255, rxload 7/255
Encapsulation HDLC, crc 16, loopback not set
Keepalive set (10 sec)
Restart-Delay is 0 secs
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters 00:07:55
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue :0/40 (size/max)
5 minute input rate 1381000 bits/sec, 1721 packets/sec
5 minute output rate 3917000 bits/sec, 1590 packets/sec
802887 packets input, 84321394 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 parity
6238 input errors, 6041 CRC, 0 frame, 19 overrun, 0 ignored, 178 abort
741267 packets output, 223596220 bytes, 0 underruns
0 output errors, 0 applique, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
rxLOS inactive, rxLOF inactive, rxAIS inactive
txAIS inactive, rxRAI inactive, txRAI inactive
NOC01#sho controllers s4/0
M1T-T3 pa: show controller:
PAS unit 0, subunit 0, f/w version 2-56, rev ID 0x2800001, version 3
idb = 0x619FE658, ds = 0x61A00158, ssb=0x61A00430
Clock mux=0x30, ucmd_ctrl=0x0, port_status=0x1
Serial config=0x8, line config=0x1B0202
maxdgram=4584, bufpool=128Kb, 256 particles
rxLOS inactive, rxLOF inactive, rxAIS inactive
txAIS inactive, rxRAI inactive, txRAI inactive
line state: up
cable type : T3 cable, received clockrate 44202795
base0 registers=0x3E000000, base1 registers=0x3E002000
mxt_ds=0x61F6A72C, rx ring entries=128, tx ring entries=256
rxring=0xF1A3940, rxr shadow=0x61A01C34, rx_head=99
txring=0xF271140, txr shadow=0x61A02260, tx_head=77, tx_tail=77, tx_count=0
throttled=0, enabled=0
rx_no_eop_err=253, rx_no_stp_err=0, rx_no_eop_stp_err=0
rx_no_buf=0, rx_soft_overrun_err=0, dump_err= 1, bogus=0, mxt_flags=0x2C
tx_underrun_err=0, tx_soft_underrun_err=0, tx_limited=0(256)
tx_fullring=10077, tx_started=35856555
Framing is c-bit, Clock Source is Line
Bandwidth limit is 44210, DSU mode 0, Cable length is 10
rx FEBE since last clear counter 1, since reset 226
Data in current interval (18 seconds elapsed):
398 Line Code Violations, 120 P-bit Coding Violation
120 C-bit Coding Violation
17 P-bit Err Secs, 0 P-bit Sev Err Secs
0 Sev Err Framing Secs, 0 Unavailable Secs
17 Line Errored Secs, 17 C-bit Errored Secs, 0 C-bit Sev Err Secs
Total Data (last 1 15 minute intervals):
16278 Line Code Violations, 5140 P-bit Coding Violation,
5107 C-bit Coding Violation,
885 P-bit Err Secs, 0 P-bit Sev Err Secs,
0 Sev Err Framing Secs, 12 Unavailable Secs,
889 Line Errored Secs, 885 C-bit Errored Secs, 0 C-bit Sev Err Secs
No alarms detected.
7500
MAN01#sho int s0/0/0
Serial0/0/0 is up, line protocol is up
Hardware is cyBus PODS3 Serial
Description: MAN01-DS3-NOC01
Internet address is ***.***.***.***/30
MTU 4470 bytes, BW 44210 Kbit, DLY 200 usec,
reliability 255/255, txload 7/255, rxload 22/255
Encapsulation HDLC, crc 16, loopback not set
Keepalive set (10 sec)
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters 00:07:46
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 3905000 bits/sec, 1576 packets/sec
5 minute output rate 1369000 bits/sec, 1722 packets/sec
724700 packets input, 218412581 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 parity
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
790994 packets output, 82205471 bytes, 0 underruns
0 output errors, 0 applique, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
LC=up CA=down TM=down LB=down TA=down LA=down
MAN01#sho controller s o/o/o
Serial0/0/0 -
Mx T3(2) HW Revision 0x3, FW Revision 3.9
Framing is c-bit, Clock Source is Line
Bandwidth limit is 44210, DSU mode 0, Cable length is 10
Data in current interval (789 seconds elapsed):
0 Line Code Violations, 0 P-bit Coding Violation
0 C-bit Coding Violation
0 P-bit Err Secs, 0 P-bit Sev Err Secs
0 Sev Err Framing Secs, 1 Unavailable Secs
0 Line Errored Secs, 0 C-bit Errored Secs, 0 C-bit Sev Err Secs
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=65496&t=65491
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
