Josh, The charger/alternator will start the charging at the higher voltage (14.4 ) and only begins to ramp it down when the acceptance of the batteries reduces the current requirements according to the programmed profile. With a voltmeter you will see it start at that voltage almost without regard to the current voltage of the combined batteries. With a charging source turned on you cannot determine the charge state of the batteries although the you could infer some status by the ammeter current measurement. Thus within moments of charging starting the ACR will close ... And with a relay all the batteries see the voltage and, of some concern, possibly high current. Both echocharge and duocharge limit the output current and voltage subject to the available inputs.
Ed On Saturday, March 28, 2015, Josh Muckley via CnC-List < cnc-list@cnc-list.com> wrote: > Wouldn't a relay also maintain float? The relays aren't supposed to turn > on until the house battery is full (~13.5v) so when the relay closes the > starting battery is actually to largest "load" on the charger. Right? > > Josh > _______________________________________________ >> >> Email address: >> CnC-List@cnc-list.com >> <javascript:_e(%7B%7D,'cvml','CnC-List@cnc-list.com');> >> To change your list preferences, including unsubscribing -- go to the >> bottom of page at: >> http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com >> >> >>
_______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com