And make sure you have zinc anodes. Electrolysis will eat something. On Aug 29, 2015 8:51 PM, "Jim Watts via CnC-List" <cnc-list@cnc-list.com> wrote:
> Put a meter on it and read what kind of voltage you are getting. 110V AC > does not generally give little shocks. > > Jim Watts > Paradigm Shift > C&C 35 Mk III > Victoria, BC > > On 29 August 2015 at 16:15, Michael Crombie via CnC-List < > cnc-list@cnc-list.com> wrote: > >> >> I'm working my way down my project list and finally got to my hot water >> tank. The PO just told me that it didn't work. I was getting 120V at the >> heating element so I checked the element and it was fried. >> >> I installed a new element and turned it on for a test. Got hot water >> after about 10 min, so I went to close everything up. But when I was doing >> that I touched the pressure relief valve and got a small shock. >> >> The green ground wire runs to one of the mouting bolts on the heating >> element and also to the water tank frame. So that seems ok. I also checked >> for continuity between the hot and neutral wires and the relief valve or >> frame and got none. >> >> So i'm puzzled. The shock wasn't big, but i definitely felt something. >> Any ideas??? >> >> Thanks, >> >> Mike >> Atacama 33 mk ii >> Toronto >> Sent wirelessly from my BlackBerry device on the Bell network. >> Envoyé sans fil par mon terminal mobile BlackBerry sur le réseau de Bell. >> _______________________________________________ >> >> Email address: >> CnC-List@cnc-list.com >> To change your list preferences, including unsubscribing -- go to the >> bottom of page at: >> http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com >> >> > > _______________________________________________ > > Email address: > CnC-List@cnc-list.com > To change your list preferences, including unsubscribing -- go to the > bottom of page at: > http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com > > >
_______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
