Sir my pc is capable of supporting 1000Mbps but when i connect the hardware and check the speed of the port it will be showing 10/100Mbps. What might the issue?and can i boost the pc speed
Thanks and regards Sandhya On Mon, Oct 21, 2013 at 10:30 AM, Sandhya G <sandhya4...@gmail.com> wrote: > ya its a new one and sir y i'am i getting unknown key format even though i > give addr=192.168.10.2 and the problem i'm facing is its showing me an > error has cannot find as a single device.I have no clue the reason for that > > Thanks and regards > Sandhya > > > On Mon, Oct 21, 2013 at 10:24 AM, Activecat <active...@gmail.com> wrote: > >> If that is a new USRP from factory then you don't need to update the >> firmware. >> >> >> >> On Mon, Oct 21, 2013 at 12:51 PM, Sandhya G <sandhya4...@gmail.com>wrote: >> >>> Thanks for the reply. >>> Well is that only problem so that i'm unable to communicate and should i >>> need to update the firmware? >>> >>> >>> Thanks and regards >>> Sandhya.G >>> >>> >>> On Mon, Oct 21, 2013 at 10:19 AM, Activecat <active...@gmail.com> wrote: >>> >>>> Your pc must have 1000Mbps port. The 10/100Mbps won't work. >>>> An alternative is to connect a 10/100/1000 LAN switch between your pc >>>> and the USRP. >>>> >>>> Rgds, >>>> activecat. >>>> >>>> >>>> On Mon, Oct 21, 2013 at 12:37 PM, Sandhya G <sandhya4...@gmail.com>wrote: >>>> >>>>> HI all, >>>>> >>>>> >>>>> I have followed as per the instructions given in the webpage for set >>>>> up of the Usrp N200/N210 but still i am unable to communicate between the >>>>> hardware and host pc >>>>> >>>>> >>>>> >>>>> 1.I have set the static ip of the host pc to >>>>> 192.168.10.1(ifconfig eth0 192.168.10.1). >>>>> >>>>> 2.Whenever i give the device address=addr=192.168.10.1 and run the grc >>>>> i am getting the error has “*unknown key format*” >>>>> >>>>> 3.Whenever i ping 192.168.10.2 or use the command uhb_find_device i >>>>> am getting warning as “*NO DEVICE FOUND* “ >>>>> >>>>> 4. Is that a must i have to upload the fpga and firmware images when >>>>> using the device for the first time. >>>>> >>>>> 5.Sometimes i am getting an error like”* unable to find as single >>>>> device”.* >>>>> >>>>> *6.*The* *host pc is supporting only 10/100MBPS .Is that the only >>>>> problem so that i am unable to communicate with the hardware. >>>>> >>>>> >>>>> >>>>> Can anybody help me on this issue.Awaiting for your valuable reply >>>>> >>>>> >>>>> Thanks in advance >>>>> >>>>> Sandhya.G >>>>> >>>>> _______________________________________________ >>>>> Discuss-gnuradio mailing list >>>>> Discuss-gnuradio@gnu.org >>>>> https://lists.gnu.org/mailman/listinfo/discuss-gnuradio >>>>> >>>>> >>>> >>> >> >
_______________________________________________ Discuss-gnuradio mailing list Discuss-gnuradio@gnu.org https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
