I asked on the rtty reflector, because, if the USB>Serial works for RTTY, it usually works for everything. The Belkin I used was a F5U103.
and one of the other RTTY guys replied with the following about the Edgeport I use one of these: Edgeport 8. Available at the below link: http://cgi.ebay.com/Inside-Out-Edgeport-8-USB-to-8-port-Serial-Converter_W0QQitemZ250316293534QQihZ015QQcategoryZ11180QQssPageNameZWDVWQQrdZ1QQcmdZViewItem It works just great for rig control (Icom 756 Pro III), FSK and rotor control. Good luck, hope this helps. But with Vista...neither may work. ----- Original Message ----- From: John To: DXBase Reflector Sent: Tuesday, October 28, 2008 11:29 AM Subject: [Dxbase] DXbase 2005 and Vista Thank you Fire Brick and Wes for your kind responses. It looks as though it will be possible to run 2005 on Vista with a little care. DXbase 2005 is fine for all my needs and apart from getting an up to date prefix mapping data base in a new version, there is nothing new I need. It would be super if one of Joe's programmes worked on DXbase 2005 as well. Getting a bit too old now to mess about with new things and as far as possible I will stay with what I know. Again my thanks, 73, John G3HTA ------------------------------------------------------------------------------ ______________________________________________________________ Dxbase mailing list Home: http://mailman.qth.net/mailman/listinfo/dxbase Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected]
______________________________________________________________ Dxbase mailing list Home: http://mailman.qth.net/mailman/listinfo/dxbase Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected]
