http://www.elecraft.com/KAT500/kat500rear_visalia.jpg
There are no BNC connectors on the back of the KAT500. The back panel (from left to right) has a heavy screw with wing nut for ground, four SO-239s (ANT3, ANT2, ANT1, XMTR), a 2.1 mm coaxial jack for 12V DC power, two RCA phono jacks for amplifier PTT key line interrupt (you would not normally use these for an Elecraft K3 / KPA500), a 3.5mm TRS jack labeled AH-4 that can be used with ICOM transceivers with a TUNE button and a four-pin Molex tune connector, a 3.5mm TRS jack labeled PC Data that uses a device like the KXUSB USB-to-serial adapter, or the same serial cable that is used for the W2 or XG3), and two 15-pin accessory connectors for connection from K3 to KAT500 to KPA500. Dick, K6KR -----Original Message----- From: elecraft-boun...@mailman.qth.net [mailto:elecraft-boun...@mailman.qth.net] On Behalf Of Rick Bates Sent: Tuesday, April 24, 2012 1:19 PM To: elecraft@mailman.qth.net Subject: Re: [Elecraft] New KAT500 pics from the Visalia DX convention Did I see BNC adapters? For THAT much energy? Not in my shack... ;-) It's time to replace the drool pads again... patience patience Rick wa6nhc On 4/24/2012 12:50 PM, Eric Swartz - WA6HHQ, Elecraft wrote: > New KAT500 pictures on our news page: > http://www.elecraft.com/news.htm ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html