Hello Don, on power up I am still getting Info 080 message and garbled frequency display (and no relays are clicking), alot of the menu functions show up correctly though, I checked the following as you indicated: RF Board U1 is oriented correctly and no pins are bent, jumper is set for INT on P7,pin 1 is soldered correctly on Front Panel U1, and my soldering is done correctly so far everywhere after re-checking all of it, I did some resistance checks on the control board, could not get a reading on the following: p2 pin 1, u3 pins: 8,13,14, u8 pins: 2,15,16 (got readings on the rest of the control panel test point checks)...for resistance checks on the front panel board I could not get a reading on the following: u1 pins 4, 13-40, j1 pins: 1-7, 9-11, 13-14 (got readings on the rest of front panel test points); for RF board resistance checks I could not get readings on the following: u1 pins: 4,9,10,28, R1 and R2, (got readings from rest of rf board test points)
thanks for your suggestions, anything else I should try at this time? thanks and 73, KE4QCM Tom Fuller -- View this message in context: http://elecraft.365791.n2.nabble.com/K2-Assembly-problems-Info-080-Message-tp7570609p7570690.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html