Jeremy,

A high SWR will cause that behavior.
Make certain the coax you are using is good. Remove it from the K2 end and check with an antenna analyzer if possible. If you cannot do that, look at the SWR registered on the wattmeter - if it is 1:1, remove the wattmeter and connect that coax to the dummy load (no wattmeter).

73,
Don W3FPR

On 3/5/2013 9:08 PM, JeremyJones wrote:
Hi Don,

The capacitors all look good, and I found one issue with a toroid and
corrected it, but the issue remains.  T4 is wound with proper number of
turns, but wires do overlap some instead of being stacked neatly.  Not sure
if this could cause an issue or not.  T4 is also standing off the board a
bit, rather than being snug to the screws underneath.

Jeremy
VA3ZTF


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

Reply via email to