Hi Ken, I am in CW mode... It acts exactly as you describe, but when in CW mode, I never see the REV below CW, and I have checked, the rig stays in CW mode...
There is some difference between this rig and the Pro III, and II... This issue never happened using the Icom rigs. It strikes me that as long as I am in CW, and not CW REV, everything should be the same, and NOTHING should matter... However, something is not the same... Right now I am suspecting that something is different in MixW, but I have my old .ini file from the Pro III days, and the setup looks the same so far... I am going through it line by line... -- Thanks and 73's, For equipment, and software setups and reviews see: www.nk7z.net for MixW support see; http://groups.yahoo.com/neo/groups/mixw/info for Dopplergram information see: http://groups.yahoo.com/neo/groups/dopplergram/info for MM-SSTV see: http://groups.yahoo.com/neo/groups/MM-SSTV/info On Sun, 2014-11-09 at 07:44 -0500, Ken wrote: > Which DATA mode you are in affects the sideband selection. DATA MODE A > normally uses USB for all bands (see the Elecraft manual on "Data Mode > Selection", page 31 in may manual. It's easy to end up with a different > Data Mode and then things vary band to band. When you activate the Data > Mode button, it shows USB or LSB. If you change data mode, or the sideband > selection, I believe those are saved on a per band basis, so when come back > to a band, you get the last selection. You might have to go through and > correct it on all the bands individually. > > Ken WA8JXM > > On Nov 4, 2014, at 10:26 AM, rs500 wrote: > > > Dave, you are not alone. I have observed the same issue on my K3. I am > > running a Signalink and FLDigi. Changing the Mode does seem to reverse the > > direction on the waterfall but then I no longer trust the frequency > > display. > > What I have found that consistently solves the problem (until the next > > occurrence) is using the K3 Utility program to restore a saved > > configuration. Unfortunately I need to close FLDigi in order for the > > utility program to connect to the K3. > > I have not definitively identified a set of events that causes the problem, > > but it seems reasonable that it is a communication problem on the serial > > port. I already have a variety of ferrite beads on the serial port and > > other cables to the computer. Good luck > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to d...@nk7z.net ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com
