If I remember correctly they got soldered from the top side. -----Original Message----- From: elecraft-boun...@mailman.qth.net <elecraft-boun...@mailman.qth.net> On Behalf Of Mark Petrovic Sent: Saturday, March 24, 2018 12:28 PM To: Elecraft@mailman.qth.net Subject: [Elecraft] Resistor and capacitor installation techniques: trim before or after soldering?
While reading through my new K2 kit's control board assembly instructions, I see that some builders prefer to trim the resistor and capacitor leads before soldering. I'm intrigued by this, and wonder if someone who uses this technique can share their experiences. Do you the solder the component from the top of the board or bottom? How do you keep the component in place during soldering? I am assuming the value of this technique is in the resulting lower profile of the components on the backside of the board. Thank you. Mark AE6RT -- Mark ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to ksto...@ac0h.net ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com
