Actually one of the important points in soldering with thru-hole
components with plated hole boards is to watch the solder flow as you
solder. You should see the solder wick down into the hole which
minimizes the chances that the lead trimming process will cause a 'shock
wave' that will fracture the solder.
Put the soldering iron in contact with both the component lead and the
solder pad (and keep it there). Apply the solder to the joint on the
opposite side from the iron (a very small bit of solder at the iron tip
will aid heat transfer). Then watch the solder flow. It should flow
out to an almost invisible edge on both the component lead and the
solder pad, then keep the heat on just a bit longer and the solder will
wick down into the thru-plated hold.
The entire process should take at least 2 seconds, but likely 3 seconds.
With heavy leads on components, it can take up to 5 seconds.
One thing that can help with fractured solder is the use of 'eutectic'
solder alloys - the 63/37 alloy is one of them. Those have no plastic
state - they go directly from molten to solid, and there is little
danger of a "cold solder joint" if anything moves during the plastic
state. The more commonly available 60/40 alloy does not have that
property, and must not be moved while the solder is cooling.
73,
Don W3FPR
On 3/24/2018 6:51 PM, Howie WA3MCK wrote:
When I went to “mil spec soldering school” at Sanders Associates in Nashua
NH back in the 80’s we were taught to install the component and
mechanically secure it BEFORE soldering. This included clipping the leads
of resistors, capacitors, and so forth.
Why?
When you clip a component lead it creates a very small “shock wave” that
passes through the lead and on to the component. In some rare cases this
MIGHT weaken the solder joint.
Our boards were even weighed before and after assembly to estimate the
total amount of solder applied.
ALL joints were inspected under a stereoscope.
All of this (and more) was part of the quality control and assurance
program.
This helped to reduce MTBF (mean time before failure) for our circuit
boards.
In my case I installed BRD-6/7 RDF surveillance receivers on Nuclear Attack
Boats.
Failure was not tolerated.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
