Meaning that I need to complete layout part before simulation right? Here simulation is done before completing layout part and after voltage divider schematic. Sir one thing is that when I used electric 9.05 and ltspiceIV older version it runs on that time. As I am using the 9.07 and ltspiceXVII what should I do?
On Sat, Oct 21, 2017 at 8:08 AM, Gavin Abo <[email protected]> wrote: > It looks like the NCC error is because your layout is incomplete. > > I opened the layout in the tutorial_1.jelib file that you sent, I get the > attached screenshot seen in "tutorial_1 from sujan.jpg". I see only one > resistor. > > There should be two resistors and wires that connect them together. It > should look like the attached screenshot in "tutorial_1 from cmosedu.jpg". > > It likes you only did the beginning part of the tutorial. The NCC error > will likely go away when you have finished the instructions > > http://cmosedu.com/videos/electric/tutorial1/electric_tutorial_1.htm > > or the video > > http://cmosedu.com/videos/electric/electric_tutorial_1_video.mp4 > > > On 10/20/2017 5:53 PM, Gavin Abo wrote: > > I opened the tutorial_1.jelib that you sent and did a Write Spice Deck. > The error "C:\R_divider.spi (Access denied)" doesn't occur on my system. > It opens just fine as seen in the attached screenshot. > On 10/20/2017 11:00 AM, sujan kanti wrote: > > > > On Saturday, October 14, 2017 at 4:15:29 AM UTC+8, Gavin wrote: >> >> I think the NCC error "vout in Cell:test_1:r_divider" in the sch box may >> be indicating that your schematic has a vout wire, but it could not find >> the matching one on the layout. So your layout may be missing vout or it >> might be mislabel (a typographical error). To more easily determine the >> cause, you would have to send the jelib file. >> >> On 10/6/2017 9:27 PM, sujan kanti wrote: >> >> >> >> On Friday, October 6, 2017 at 10:36:36 PM UTC+8, sujan kanti wrote: >>> >>> Hello Sir, >>> I followed everything according to Dr. Jacob tutorial 1. At the time of >>> simulation i found this error.How can I repair it? please help me. >>> >>> I have attached the problem >>> >> > -- > You received this message because you are subscribed to a topic in the > Google Groups "Electric VLSI Editor" group. > To unsubscribe from this topic, visit https://groups.google.com/d/ > topic/electricvlsi/tkyE5fgf-cE/unsubscribe. > To unsubscribe from this group and all its topics, send an email to > [email protected]. > For more options, visit https://groups.google.com/d/optout. > -- You received this message because you are subscribed to the Google Groups "Electric VLSI Editor" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
