Jon Elson wrote: >Chris Radek wrote: > > >>[snip] >> >>G92.1 (clear G92 offset to go back to the normal G54) >>M2 >> >> >Well, this will work, but it upsets the alignment of the G54 >system, and you can't get that restored with a G54. So, I kind >of like my scheme to set the G55 system relative to the G54 >system by use of a G10 L2 P2 X#5211+(value) I still have to >test this out, but it seems like it has to work, possibly with a >little tweak. > > You could always save the offsets in other vars, like #1001..#1009 = #5211..#5219 when you touch off. Then, when you do the G92.1 to reset, just move to 0,0,0 (,0,0,0), and issue G92 X#1001 Y#1002 Z#1003 (maybe negative, you'd have to experiment) to restore the original G54 offset.
If you make subroutines for saving and restoring the parameters, it would make things very simple. - Steve ------------------------------------------------------------------------- Sponsored by: SourceForge.net Community Choice Awards: VOTE NOW! Studies have shown that voting for your favorite open source project, along with a healthy diet, reduces your potential for chronic lameness and boredom. Vote Now at http://www.sourceforge.net/community/cca08 _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
