Don't forget to check the PDF documentation first since that is the one that comes with the EMC2 system and check what else is missing or not according to the reality there.
On 7/9/08, Jon Elson <[EMAIL PROTECTED]> wrote: > Chris Radek wrote: > > On Tue, Jul 08, 2008 at 12:37:07PM -0400, Stephen Wille Padnos wrote: > > > >>You could always save the offsets in other vars, like #1001..#1009 = > >>#5211..#5219 when you touch off. > >>Then, when you do the G92.1 to reset, just move to 0,0,0 (,0,0,0), and > issue > >>G92 X#1001 Y#1002 Z#1003 (maybe negative, you'd have to experiment) > >>to restore the original G54 offset. > > > > > > G92.1 **does** put you back at the original G54 offset. The G54 > > variables are not changed by the G92 codes. > > > > I think everyone wants to make this more difficult than it is. > > Well, now my understanding of the work offsets, G92, G54/G55 > etc. and all is totally fouled up! I'm going to have to go and > read the docs, and play with the system a bunch more, and try to > figure out what does what! > > > Jon > > > ------------------------------------------------------------------------- > Sponsored by: SourceForge.net Community Choice Awards: VOTE NOW! > Studies have shown that voting for your favorite open source project, > along with a healthy diet, reduces your potential for chronic lameness > and boredom. Vote Now at http://www.sourceforge.net/community/cca08 > _______________________________________________ > Emc-developers mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-developers > ------------------------------------------------------------------------- Sponsored by: SourceForge.net Community Choice Awards: VOTE NOW! Studies have shown that voting for your favorite open source project, along with a healthy diet, reduces your potential for chronic lameness and boredom. Vote Now at http://www.sourceforge.net/community/cca08 _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
