Does anyone use the Xylotex 3 or 4 axis board?
As I understand it all on has to do is plug the parallel cable into
the board and wire up the motors and power supply.
Is there any other all in one cards for steppers?
I noticed that on the EMC2 Supported Hardware page that the Gecko
drives are not listed. Are they not supported?
http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl?EMC2_Supported_Hardware
Thanks
John
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
