Hi Dave Can't help you with the board driver but I can say that I've used IOSH the same way to initialize several similar boards. In fact if you look around a bit, there was a Tcl/Tk script named DIO_Exercise.tcl that showed a graphical display of the full set of 8255 ports. That would allow you to set each as IO given the way you set the control port.
Rayh On Sun, 2007-09-09 at 13:12 -0500, [EMAIL PROTECTED] wrote: > Help !! > I have been struggling to get my Acess DIO-48 board working without much > success. I have been trying to get the ax5214h driver to work with it in > order to use HAL on my Hardinge project. I figured it should be the same, > both use 8255 etc. My opinion is that the config byte is different. if I > open a second terminal, and run IOSH to set the high bit in the config > register ( of the 8255), everything works fine. (a hassel to use in that > manner, but fine for testing ) so > I have looked at the source code and cannot see that bit being set. My > understanding of "C" is very aboriginal. I do not know how to compile the > code even if I could correct it. What to do? > Thanks, Dave > > > ------------------------------------------------------------------------- > This SF.net email is sponsored by: Microsoft > Defy all challenges. Microsoft(R) Visual Studio 2005. > http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2005. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
