On Sunday 09 September 2007, John Thornton wrote: >Does anyone use the Xylotex 3 or 4 axis board? > >As I understand it all on has to do is plug the parallel cable into >the board and wire up the motors and power supply. > I have a 3 axis that works great. And I at the time had to build a patchbox for the parport cuz the xylotex has a slightly different pinput assignment, but I could skip that now as there is an emc2 stepper config that has been configured to talk to the xylotex correctly.
>Is there any other all in one cards for steppers? > >I noticed that on the EMC2 Supported Hardware page that the Gecko >drives are not listed. Are they not supported? > >http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl?EMC2_Supported_Hardware > >Thanks >John -- Cheers, Gene "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) James Joyce -- an essentially private man who wished his total indifference to public notice to be universally recognized. -- Tom Stoppard ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2005. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users