I would suggest that what you need is a way to set the MAC address; not the IP address. Then you could set the IP address by using DHCP. You could also use TFTP to download the code to it using onboard boot flash.
It's a bit more work (particularly in small volume), but the MAC address could also be flashed into each machine. Ken [EMAIL PROTECTED] Mark Kenny Products Company, LLC 55 Main Street Voice: (888)ISO-SEVO (888)476-7386 Newtown, CT 06470 Fax: (203)426-9138 http://www.MarkKenny.com -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of Jon Elson Sent: Monday, September 10, 2007 1:49 AM To: Enhanced Machine Controller (EMC) Subject: Re: [Emc-users] G100+emc2 Alan Condit wrote: > Jon, > >>Jon wrote: >>Why do you want the G100? There are a number of cheaper, more >>capable interfaces to step/direction drives that give you a >>number of advanced features the G100 still lacks. For instance, >>my Universal Stepper Controller : >> >>http://jelinux.pico-systems.com/univstep.html >> >>It is only $250, and it allows you to connect encoders so you >>can detect actual position at all times, even when you crash or >>hit E-stop, it also has opto-isolators for 16 digital inputs and >>positions to plug in 8 solid state relays for spindle, coolant, >>etc. Finally, it supports spindle sync for lathe threading and >>rigid tapping. >> >>As far as I know, no one is working on interfacing the G-100 to EMC. >> >>Jon > > > Some of us are still hoping someday to not have to use a parallel > port to communicate with the CNC machine. I personally am hoping > someday to be able to control EMC2 from my Mac (read no parallel > ports). USB or ethernet look like the most likely prospects. The > solution may be to use something like G100 or ARC100 at the machine > and axis running remote but, we can always dream that someone will > find a solution to allow EMC2 to operate over USB or ethernet. I'm working on it! At least, I am looking at microcontrollers that have ethernet built in, and some amount of I/O pins. I've got one picked out, but it has availability problems, so I am waiting just a little to see if that gets resolved. I still need to get the development software for it, and work out how to use the Linux real-time ethernet driver. I am hoping to do this this fall, and have an add-on board that will be quite cheap. It needs one of these all-in-one microcontrollers, an ethernet jack, a quartz crystal, some voltage regulators, and not a whole lot else. I also need some method to set the IP address, either USB or serial port, I guess. Jon ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2005. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2005. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
