> On Mon, Sep 10, 2007 at 10:28:37PM +0000, Neil Buck wrote: > >>I'm half way through retrofitting a Cincinnati VMC with a MESA m5i20 setup. I >>would welcome some advice as to the best way to control the spindle. My goal >>is >>to be able to do rigid tapping and fully automatic tool changes. My thoughts >>are One other point is that you may do best by putting the spindle in high gear and running the motor VERY slow, a speed range setting that would not normally be used. This will allow the spindle to reverse very quickly.
I was doing some tapping with a tapping head at 1200 RPM recently, and the spiral-flute taps performed MUCH better at that speed (in aluminum, 4-40 thread) than at lower speeds. I don't have a spindle encoder on my machine, yet, so i still have to use the tapping head to do the reversing. Jon ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2005. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users