the only other thing I can think of is that the max step/sec is a bit on the low side. But I don't know a good safe step rate to put on paper. (~20k/s w/Parport) - expecially because 2.2 will have doublefreq which will increase the step rate a bit more.
sam ----- Original Message ----- From: "Kirk Wallace" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]>; "Enhanced Machine Controller (EMC)" <[email protected]> Sent: Tuesday, October 02, 2007 1:51 PM Subject: Re: [Emc-users] Desktop CNC Website Information > Updated here: > > http://www.wallacecompany.com/cnc_lathe/control_table-kw1a.htm > > Kirk Wallace > ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ > On Tue, 2007-10-02 at 13:36 -0400, Stephen Wille Padnos wrote: >> Cool. >> >> A few changes though: >> >> Name: EMC2 >> Additional Hardware: optional >> Max Axes: 9 (XYZ linear, ABC angular, UVW linear) > ... snip > > > ------------------------------------------------------------------------- > This SF.net email is sponsored by: Microsoft > Defy all challenges. Microsoft(R) Visual Studio 2005. > http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2005. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
