oh - and maybe a rigid tapping column.. The threading lathe/mill is a bit odd.. Mach does not do rigid tapping which I would concider the mill threading (it has yes/yes in that column).
----- Original Message ----- From: "Sam Sokolik" <[EMAIL PROTECTED]> To: "Enhanced Machine Controller (EMC)" <emc-users@lists.sourceforge.net> Sent: Tuesday, October 02, 2007 2:20 PM Subject: Re: [Emc-users] Desktop CNC Website Information > the only other thing I can think of is that the max step/sec is a bit on > the > low side. But I don't know a good safe step rate to put on paper. > (~20k/s > w/Parport) - expecially because 2.2 will have doublefreq which will > increase > the step rate a bit more. > > sam > ----- Original Message ----- > From: "Kirk Wallace" <[EMAIL PROTECTED]> > To: <[EMAIL PROTECTED]>; "Enhanced Machine Controller (EMC)" > <emc-users@lists.sourceforge.net> > Sent: Tuesday, October 02, 2007 1:51 PM > Subject: Re: [Emc-users] Desktop CNC Website Information > > >> Updated here: >> >> http://www.wallacecompany.com/cnc_lathe/control_table-kw1a.htm >> >> Kirk Wallace >> ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ >> On Tue, 2007-10-02 at 13:36 -0400, Stephen Wille Padnos wrote: >>> Cool. >>> >>> A few changes though: >>> >>> Name: EMC2 >>> Additional Hardware: optional >>> Max Axes: 9 (XYZ linear, ABC angular, UVW linear) >> ... snip >> >> >> ------------------------------------------------------------------------- >> This SF.net email is sponsored by: Microsoft >> Defy all challenges. Microsoft(R) Visual Studio 2005. >> http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ >> _______________________________________________ >> Emc-users mailing list >> Emc-users@lists.sourceforge.net >> https://lists.sourceforge.net/lists/listinfo/emc-users > > > ------------------------------------------------------------------------- > This SF.net email is sponsored by: Microsoft > Defy all challenges. Microsoft(R) Visual Studio 2005. > http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2005. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
