I am surprized that Mach under Windows could out perform EMC in steps/sec since EMC is built on a realtime kernel.
I presume it is therefore that it is the "quality of steps" that EMC is better at? In otherowrds EMC produces more accurate and precise steps. ----- Original Message ----- From: "Sam Sokolik" <[EMAIL PROTECTED]> To: "Enhanced Machine Controller (EMC)" <[email protected]> Sent: Tuesday, October 02, 2007 3:20 PM Subject: Re: [Emc-users] Desktop CNC Website Information > the only other thing I can think of is that the max step/sec is a bit on > the > low side. But I don't know a good safe step rate to put on paper. > (~20k/s > w/Parport) - expecially because 2.2 will have doublefreq which will > increase > the step rate a bit more. > > sam > ----- Original Message ----- > From: "Kirk Wallace" <[EMAIL PROTECTED]> > To: <[EMAIL PROTECTED]>; "Enhanced Machine Controller (EMC)" > <[email protected]> > Sent: Tuesday, October 02, 2007 1:51 PM > Subject: Re: [Emc-users] Desktop CNC Website Information > > >> Updated here: >> >> http://www.wallacecompany.com/cnc_lathe/control_table-kw1a.htm >> >> Kirk Wallace >> ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ >> On Tue, 2007-10-02 at 13:36 -0400, Stephen Wille Padnos wrote: >>> Cool. >>> >>> A few changes though: >>> >>> Name: EMC2 >>> Additional Hardware: optional >>> Max Axes: 9 (XYZ linear, ABC angular, UVW linear) >> ... snip >> >> >> ------------------------------------------------------------------------- >> This SF.net email is sponsored by: Microsoft >> Defy all challenges. Microsoft(R) Visual Studio 2005. >> http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ >> _______________________________________________ >> Emc-users mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/emc-users > > > ------------------------------------------------------------------------- > This SF.net email is sponsored by: Microsoft > Defy all challenges. Microsoft(R) Visual Studio 2005. > http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2005. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
