Re: [Emc-users] Home and Limit Switch Setup in Stepconf

Fri, 18 Jan 2008 05:03:31 -0800

I am using 2.2.2
What kind of bugs? Is it possible to edit the conf file manually?
Can EMC handle sharing the home and min. limit switch on each axis individually?
Of course, I would like to avoid rewiring.

Thanks,
Chris

Dean Hedin wrote: 
Chris make sure you are up to version 2.2.2
There are some bugs in the wizard regarding home/limit switch setup.

You may find it easier to just rewire the switches.

The "most simple" configuration is to put all the homes on one pin and
all the limits on another pin.  Have a pull up resistor on each pin and any 
on of the switches can pull
the line to ground.



----- Original Message ----- 
From: "Chris Barker" <[EMAIL PROTECTED]>

  
Good Evening,

I am working through the setup of my router table using the Stepconf 
Wizard.
I have a question about how to configure my home and limit switches in
the wizard.
My machine is already setup and running using Turbocnc.
The way I already have my limits setup is:

Each axis has it's own home switch. The home switch also acts as a
minimum limit when home isn't being used.
3 input pins are used. Active low.

Maximum travel limits are combined on all axes in a serial conection.
Active low.
Only 1 pin is used on the par. port.
    


-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users


  

-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to