Good Evening,

I am working through the setup of my router table using the Stepconf Wizard.
I have a question about how to configure my home and limit switches in 
the wizard.
My machine is already setup and running using Turbocnc.
The way I already have my limits setup is:

Each axis has it's own home switch. The home switch also acts as a 
minimum limit when home isn't being used.
3 input pins are used. Active low.

Maximum travel limits are combined on all axes in a serial conection. 
Active low.
Only 1 pin is used on the par. port.

Stepconf doesn't seem to give me these options.
Is there another way I can set it up in the software?

Thanks,
Chris Barker


-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to