There is only 3 that I know of including yours... and l'd love to be proved wrong...
http://axis.unpythonic.net/01187535387 http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl?PyVCP John On 24 Mar 2008 at 12:04, Anders Wallin wrote: > > So my question is it possible to make standard software inside of > > EMC2 that uses 4th connector on 5I20 and some kind standard board > > like MESA Electronics made breaker board for axis motors. I think > > most jogger wheel uses 6 connectors. > > I would love to be proved wrong, but amazingly my quick-and-dirty > writeup of a simple jog-pendant test from Nov 2006 is one of the few > online descriptions of how to do this: > http://www.anderswallin.net/2006/11/jogging-emc2/ > > Anders > > ---------------------------------------------------------------------- > --- This SF.net email is sponsored by: Microsoft Defy all challenges. > Microsoft(R) Visual Studio 2008. > http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ > _______________________________________________ Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users