On Tue, 2008-06-17 at 22:54 -0400, Sergey Izvoztchikov wrote: > Hello, > > I've recently joined this group. Going CNC direction with my > Sherline lathe and mill. Could not find much info about support > for Ohmikron SDS0707 CNC control system under EMC or EMC2. > > Are there any happy user of this CNC driver under EMC/EMC2 ? > How hard was it to configure EMC and is there already available > configuration ? Please voice your opinion on pros and cons of > this system. > > Thanks a lot in advance for anybody who could help. > > Cheers.
I don't know if Phil from Ohmikron is on this list, but I think he is active on the DIY-CNC list in Yahoo Groups http://groups.yahoo.com/group/DIY-CNC/ My impression was that the SDS0707 was designed to work with Mach, so I also assume the parallel port is used to give the SDS step and direction signals. EMC should be fine with that arrangement. All of the necessary signals from EMC can be assigned to any appropriate parallel port pin. If you have a manual or schematic indicating the pin functions on the SDS, you can use that to edit a sample stepper configuration file to match. EMC also has a stepper configuration wizard too. If you supply enough detail on your setup to the list, I am sure you will get help to get it working. Are you converting your Sherline's from a manual configuration? How much of the CNC system do you have in hand? How would you like to control the mill or lathe spindle speed? -- Kirk Wallace (California, USA http://www.wallacecompany.com/machine_shop/ Hardinge HNC/EMC CNC lathe, Bridgeport mill conversion, doing XY now, Zubal lathe conversion pending Craftsman AA 109 restoration Shizuoka ST-N/EMC CNC) ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://sourceforge.net/services/buy/index.php _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users