Donnie Timmons wrote: > I put this in the hal file the only thing different is it now pulses the > output when EMC starts up but I still can not control it. Right now I'm only > looking at the brake output. I'm sure that once I get the brake working the > other will be the same problem. > > # Connect spindle brake to I/O controller. > newsig SpindleBrakeOn bit > setp hm2_5i23.0.gpio.P3.042.is_output 1 > linksp SpindleBrakeOn => hm2_5i23.0.gpio.P3.042.out > linksp SpindleBrakeOn <= motion.spindle-brake > > > My Fluke 23 tells me all the inputs are pulled high. Grounding them make no > difference on what the Halmeter is showing but my Fluke sure sees it.
I'll take a look at it over the weekend. -- Sebastian Kuzminsky Free! Free! As a Journey Man! Feel! Heat! In the moon light! -- Korpiklaani ------------------------------------------------------------------------------ This SF.net email is sponsored by: SourcForge Community SourceForge wants to tell your story. http://p.sf.net/sfu/sf-spreadtheword _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users