On Fri, 27 Mar 2009 17:54:27 -0600, you wrote: > > >On 27 Mar 2009 at 22:29, Steve Blackmore wrote: > >> >> I found the NO_FORCE_HOMING=1 in the wiki. > >it is in the manual... > >http://www.linuxcnc.org/docview/devel/html//config_ini_config.html#sub:[TRAJ]-section
Yea - I was looking in the "homing" section of the 2.2 manual. >Are you using Touch Off P1? > >If you don't have a tool "loaded" you don't get the option to set the tool >table. I did. I found that stepconf doesn't create a lathe style tooltable, and if you do try to touch a tool off, it fails with "cannot have an x tool offset with orientation 0" A couple of other things, Axis doesn't seem to remember window resizing? What defines where the origin point on the screen is on startup (cyan crossed circle) - It's always off the screen up to the left? Steve Blackmore -- ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users