Hi The interesting part is that all system did work perfectly and no problem. I just desassemble and wire same way and now none of the motor turns. All encoders works, i can see connections and no matter of jag increments systems brings ERROR- joint folloving - instantly!
i try - Calibration and after i change valume of P I D and run and click Refresh P I D stay same. After click refresh on Calibration, should valume of P I D become same as in INI File? i think it should but in my case it is not. So, maybe my EMC2 got corapted for some reasons, and i need reinstall EMC2? Thanks Aram > Assuming that Aram has the SD94P Servo Dynamics drives like the one he > had at fest a few years ago: they have special software for internal > tuning that should serve as a good check of the drive/motor. > I don't know if the MotionView software runs on Linux. > > If that works then he can move on to checking the signals to the drive. > > Just my tuppence. > > Dave > > On Tue, 2010-09-07 at 06:58 -0500, Stuart Stevenson wrote: >> Aram, >> You need to make sure your configuration is sending the signal to the >> motor. To confirm if the motor works you should move the motor back to >> the >> machine where you know it worked. If it works on the old machine then >> the >> problem is in the setup on the new machine. >> thanks >> Stuart >> >> On Mon, Sep 6, 2010 at 9:28 PM, <a...@conceptmachinery.com> wrote: >> >> > Hi >> > i got problem after i removed system from one machine and install on >> > another. i maybe wire something wrong. >> > i want to ask 2 things: >> > 1. on one axis when i jog, on monitor it show that axis move but motor >> by >> > them self didn't move at all. what this mean? >> > 2. i used tester and check resistance OM between U-V-W wire from >> motor >> > (nema 34 servodynamis AC servo) and it show that that they link. is >> motor >> > bad? >> > >> > thanks >> > aram >> > >> > >> > >> > ------------------------------------------------------------------------------ >> > This SF.net Dev2Dev email is sponsored by: >> > >> > Show off your parallel programming skills. >> > Enter the Intel(R) Threading Challenge 2010. >> > http://p.sf.net/sfu/intel-thread-sfd >> > _______________________________________________ >> > Emc-users mailing list >> > Emc-users@lists.sourceforge.net >> > https://lists.sourceforge.net/lists/listinfo/emc-users >> > >> >> >> > > > ------------------------------------------------------------------------------ > This SF.net Dev2Dev email is sponsored by: > > Show off your parallel programming skills. > Enter the Intel(R) Threading Challenge 2010. > http://p.sf.net/sfu/intel-thread-sfd > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ This SF.net Dev2Dev email is sponsored by: Show off your parallel programming skills. Enter the Intel(R) Threading Challenge 2010. http://p.sf.net/sfu/intel-thread-sfd _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
