Assuming that Aram has the SD94P Servo Dynamics drives like the one he had at fest a few years ago: they have special software for internal tuning that should serve as a good check of the drive/motor. I don't know if the MotionView software runs on Linux.
If that works then he can move on to checking the signals to the drive. Just my tuppence. Dave On Tue, 2010-09-07 at 06:58 -0500, Stuart Stevenson wrote: > Aram, > You need to make sure your configuration is sending the signal to the > motor. To confirm if the motor works you should move the motor back to the > machine where you know it worked. If it works on the old machine then the > problem is in the setup on the new machine. > thanks > Stuart > > On Mon, Sep 6, 2010 at 9:28 PM, <a...@conceptmachinery.com> wrote: > > > Hi > > i got problem after i removed system from one machine and install on > > another. i maybe wire something wrong. > > i want to ask 2 things: > > 1. on one axis when i jog, on monitor it show that axis move but motor by > > them self didn't move at all. what this mean? > > 2. i used tester and check resistance OM between U-V-W wire from motor > > (nema 34 servodynamis AC servo) and it show that that they link. is motor > > bad? > > > > thanks > > aram > > > > > > > > ------------------------------------------------------------------------------ > > This SF.net Dev2Dev email is sponsored by: > > > > Show off your parallel programming skills. > > Enter the Intel(R) Threading Challenge 2010. > > http://p.sf.net/sfu/intel-thread-sfd > > _______________________________________________ > > Emc-users mailing list > > Emc-users@lists.sourceforge.net > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > > ------------------------------------------------------------------------------ This SF.net Dev2Dev email is sponsored by: Show off your parallel programming skills. Enter the Intel(R) Threading Challenge 2010. http://p.sf.net/sfu/intel-thread-sfd _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users