As I mentioned before - We home using 2 micro switches. one switch is on the linear slide and one is on the timing gear.
http://www.electronicsam.com/images/KandT/homesw.jpeg the 2 switches are hooked in series. so when the linear closes then it waits for the one on the timing gear to close. then it does the homing dance. :) I would think you could do the same thing (in hal) with the index pulse - just go slow enough that you won't miss it. (I do the same thing) sam On Thu, 2 Dec 2010 15:23:05 +0000 andy pugh <bodge...@gmail.com> wrote: > On 2 December 2010 15:08, Tom Easterday <tom-...@bgp.nu> wrote: > > perhaps makes me surprised that the EMC user base is just homing > > inaccurately and warm and fuzzy in their ignorance. > > There may be a bit of that. I know that it would be nice if my lathe > held diameter to better than 0.1mm through a restart, but I just > accept I need to measure diameter at some point and re-touch-off. > > -- > atp > "Torque wrenches are for the obedience of fools and the guidance of wise men" > > ------------------------------------------------------------------------------ > Increase Visibility of Your 3D Game App & Earn a Chance To Win $500! > Tap into the largest installed PC base & get more eyes on your game by > optimizing for Intel(R) Graphics Technology. Get started today with the > Intel(R) Software Partner Program. Five $500 cash prizes are up for grabs. > http://p.sf.net/sfu/intelisp-dev2dev > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Increase Visibility of Your 3D Game App & Earn a Chance To Win $500! Tap into the largest installed PC base & get more eyes on your game by optimizing for Intel(R) Graphics Technology. Get started today with the Intel(R) Software Partner Program. Five $500 cash prizes are up for grabs. http://p.sf.net/sfu/intelisp-dev2dev _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users