http://linuxcnc.org/docview/html/gcode_main.html#sub:G61,-G61.1,-G64:
Regards, Alex ----- Original Message ----- From: "Doug" <d...@archfitters.com> To: "'Enhanced Machine Controller (EMC)'" <emc-users@lists.sourceforge.net> Sent: Friday, March 18, 2011 4:45 PM Subject: Re: [Emc-users] Gcode Question > When I use two G0 rapid moves the program rounds the corner. How can a > make > a rapid move in a straight line in one axis and then when finished run > another rapid move on another axis in a straight line. It runs straight > and > then curves the end point to go into the second rapid. Is seems to look > ahead and cuts the corner to same time. > > Doug > > > ------------------------------------------------------------------------------ > Colocation vs. Managed Hosting > A question and answer guide to determining the best fit > for your organization - today and in the future. > http://p.sf.net/sfu/internap-sfd2d > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ Colocation vs. Managed Hosting A question and answer guide to determining the best fit for your organization - today and in the future. http://p.sf.net/sfu/internap-sfd2d _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
