That looks like it'll do it. > And what would I need to go with it
safety glasses :-) also, it looks like the nut is a separate part number, so you'll need that, and if it doesn't come with the collet you'll need an ER-11 1/8" collet, like this one: http://www.amazon.com/Royal-Products-Diameter-Ultra-Precision-Collet/dp/B0037QG9NG/ref=sr_1_2?ie=UTF8&qid=1320269890&sr=8-2 DougM On Wed, Nov 2, 2011 at 2:17 PM, <kqt4a...@comcast.net> wrote: > On Wed, 2 Nov 2011, Kirk Wallace wrote: > >> On Wed, 2011-11-02 at 08:41 -0500, kqt4a...@comcast.net wrote: >>> On Wed, 2 Nov 2011, andy pugh wrote: >>> >>>> On 2 November 2011 09:03, <kqt4a...@comcast.net> wrote: >>>> >>>>> That is my other option but I have realign my work >>>>> For this project I start with 1/4" bit to remove a lot of material >>>>> Then switch to a 1/8" bit then to a 1/16" bit to finish >>>>> If I change routers I have to hope I get the alignment correct >>>> >>>> >>>> Do you have access to a lathe? It should be possible to modify one of >>>> the existing extensions, though I think I would be more tempted to >>>> modify one of these: >>>> http://www.ebay.co.uk/itm/ER11-10MM-STRAIGHT-SHANK-L100MM-CHUCK-CNC-MILLING-LATHE-TOOL-WORKHOLDING-L29-/150688723489 >>> >>> I do not have access to a lathe >>> I may have to make friends with a local machinist >>> Could get pricey >>> >>> Another thought I had was to scrounge for an old dremel and cut off the >>> shaft >> >> This ER tool holder could be used with a couple of bearings, pulleys and >> timing belt to your existing spindle motor. >> >> For one of my problems, I'm thinking I could use these holders to modify >> my useless double angle NMTB 40 holders. Just bore them out a couple of >> tenths (.0002") under sized. Heat the holder and press the shaft in. >> Although I can get normal holders for around $40 each. It might be worth >> it if I do a batch. >> > > Not being very machinist savvy hope y'all will not mind one more question > Is this what I am looking for > http://pdf.directindustry.com/pdf/hardinge-workholding/toolholder-collets-bushings-tool-holders/17884-13582-_19.html > Part number 7997-60-08-002500 > And what would I need to go with it > > > ------------------------------------------------------------------------------ > RSA(R) Conference 2012 > Save $700 by Nov 18 > Register now > http://p.sf.net/sfu/rsa-sfdev2dev1 > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ RSA(R) Conference 2012 Save $700 by Nov 18 Register now http://p.sf.net/sfu/rsa-sfdev2dev1 _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users