Hello kqt4at5v (what a name!) this kind of collet is the standard tool holder on my Steinel vertical mill, in size ER40 with a Morse taper 3 shank. Very reliable, just once, with very large cutting force in cast iron, the 12 mm bit got pulled out gradually, digging deeper and deeper. I noticed that after more than 200 mm of milling a groove, by this time the bit had a cutting depth of about 20 mm - at least I knew after this that my machine was capable of doing much more in one cut than I had ever tried! I wish that the holder were shorter so I could use more of the heigth above table.
Peter > Not being very machinist savvy hope y'all will not mind one more question > Is this what I am looking for > http://pdf.directindustry.com/pdf/hardinge-workholding/toolholder-collets-bushings-tool-holders/17884-13582-_19.html > Part number 7997-60-08-002500 > And what would I need to go with it > > > ------------------------------------------------------------------------------ > RSA(R) Conference 2012 > Save $700 by Nov 18 > Register now > http://p.sf.net/sfu/rsa-sfdev2dev1 > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > > ------------------------------------------------------------------------------ RSA(R) Conference 2012 Save $700 by Nov 18 Register now http://p.sf.net/sfu/rsa-sfdev2dev1 _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
