Also, I have another 3-axis config that does exactly the same thing; a third one also did that but I chose not to save it after testing the motors from within the Stepconf wizard.
On 29/7/13 at 10:37 AM, [email protected] wrote: > Here's the pertinent files relating to my axis weirdness: > > 3-axis hal file = > > 3-axis INI file = > > 3-axis Stepconf = (for completeness). > > Thanks again to Stuart for the suggestion :). > > Alex > > ----- Original Message ----- > From: "Enhanced Machine Controller (EMC)" > To:"Enhanced Machine Controller (EMC)" > Cc: > Sent:Sun, 28 Jul 2013 23:30:50 +1000 > Subject:Re: [Emc-users] Stepconf/BoB weirdness with LinuxCNC > > Thanks Stuart. I'll get onto that tomorrow (Aus time) when I have the > box booted up (the computer is in the control box) > > Cheers, > Alex. > > On 28/07/2013, at 10:54 PM, Stuart Stevenson wrote: > > > Posting information such as the .INI and .hal files would allow > much deeper > > analysis. > > In this instance pastebin is your friend. > > > ------------------------------------------------------------------------------ > > See everything from the browser to the database with AppDynamics > > Get end-to-end visibility with application monitoring from > AppDynamics > > Isolate bottlenecks and diagnose root cause in seconds. > > Start your free trial of AppDynamics Pro today! > > > http://pubads.g.doubleclick.net/gampad/clk?id=48808831&iu=/4140/ostg.clktrk > > _______________________________________________ > > Emc-users mailing list > > [email protected] > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > ------------------------------------------------------------------------------ > See everything from the browser to the database with AppDynamics > Get end-to-end visibility with application monitoring from > AppDynamics > Isolate bottlenecks and diagnose root cause in seconds. > Start your free trial of AppDynamics Pro today! > http://pubads.g.doubleclick.net/gampad/clk?id=48808831&iu=/4140/ostg.clktrk > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > > ------------------------- > Email sent using Optus Webmail > ------------------------------------------------------------------------------ > See everything from the browser to the database with AppDynamics > Get end-to-end visibility with application monitoring from AppDynamics > Isolate bottlenecks and diagnose root cause in seconds. > Start your free trial of AppDynamics Pro today! > http://pubads.g.doubleclick.net/gampad/clk?id=48808831&iu=/4140/ostg.clktrk > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ See everything from the browser to the database with AppDynamics Get end-to-end visibility with application monitoring from AppDynamics Isolate bottlenecks and diagnose root cause in seconds. Start your free trial of AppDynamics Pro today! http://pubads.g.doubleclick.net/gampad/clk?id=48808831&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
