On 6 April 2014 21:43, Peter C. Wallace <p...@mesanet.com> wrote: > 1. You are using any of the above bitfiles > 2. You are using the hardware stepgen > 3. You are using linuxcnc master > > There may be a conflict, and I suggest not using master until the bitfiles are > updated. I plan to update all these bitfiles by removing the table mode pins > sometime next week.
I think we have a plan B which is better. I will add a flag to the hostmot2 modparam so that the extra pins need to be actively enabled. Starting from scratch it would have been nice to make num_stepgen=22288 (for example) to create 3 x step-dir and 3x 8-pin table stepgens, but it's too late now. -- atp If you can't fix it, you don't own it. http://www.ifixit.com/Manifesto ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
