Hi what i have-- machine working. can home machine. move away from home switch by jog negative. can program with mdi -g1 g91 y-2 f4. --- and it move the axis. all good when i introduce m52 p1 axis stop moving. simple program trough mdi stop working-moving axis. i can not jog any axis. need close emc2 start again and than i can jog and program axis.
i use m52 p0 and it did not help. i did post few e-mail back ini and hal any idea where is problem? thanks aram On Mon, Jul 21, 2014 at 4:46 AM, andy pugh <[email protected]> wrote: > On 21 July 2014 06:59, a k <[email protected]> wrote: > > > to stop m52 p1 is m53 > > M53 is Feed Stop Control, it enables the feed-hold pin, it doesn't > disable adaptive feed. > > http://www.linuxcnc.org/docs/html/gcode/m-code.html#sec:M52-Adaptive-Feed-Control > M52 P0 turns off adaptive feed. > > -- > atp > If you can't fix it, you don't own it. > http://www.ifixit.com/Manifesto > > > ------------------------------------------------------------------------------ > Want fast and easy access to all the code in your enterprise? Index and > search up to 200,000 lines of code with a free copy of Black Duck > Code Sight - the same software that powers the world's largest code > search on Ohloh, the Black Duck Open Hub! Try it now. > http://p.sf.net/sfu/bds > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ Want fast and easy access to all the code in your enterprise? Index and search up to 200,000 lines of code with a free copy of Black Duck Code Sight - the same software that powers the world's largest code search on Ohloh, the Black Duck Open Hub! Try it now. http://p.sf.net/sfu/bds _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
