Hi All, First, I am pretty new to all of everything. I am hoping someone can point me back in the right direction.
I am trying to get my bench setup running. I have a single nema 17 motor connected to a Gecko G540 using a 24V PS. I can power up the G540 with the charge pump off and the motor holds and the light is green. This seems to be a success. I cannot get LCNC to talk to the G540. Using Stepconf Wizard, I trying setting Parport Base Address to 0, 1, 0x378, 0x278, 0x3BC, 0x378 in 0xd010 in, 0x378 in 0xd000 in. None seem to work. I suspect the PCIE card is not communicating correctly. Pin 16 is always set to charge pump. The card is a SD-PEX1005. I bought it since someone in the newegg reviews said it works with LCNC. I trying following the linux driver install directions, but quickly became lost. The directories do not match up?? http://www.sybausa.com/productInfo.php?iid=611 Below is more information about the parallel port. *lspci -vvv* 04:00.0 Parallel controller: NetMos Technology Device 9900 (prog-if 03 [IEEE1284]) Subsystem: Device a000:2000 Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx- Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx- Latency: 0, Cache Line Size: 64 bytes Interrupt: pin A routed to IRQ 11 Region 0: I/O ports at d010 [size=8] Region 1: I/O ports at d000 [size=8] Region 2: Memory at f7c01000 (32-bit, non-prefetchable) [size=4K] Region 5: Memory at f7c00000 (32-bit, non-prefetchable) [size=4K] Capabilities: <access denied> from here: http://www.vdwalle.com/Norte/Second%20Parport.htm *bill@CNC:~/Desktop$ ./ppdiag* WARNING: You are not runnig this script as 'root'. Only a few checks will be done. No configuration update will be done. S01: parport built as module cat: /proc/sys/dev/parport/p*/irq: No such file or directory ./ppdiag: line 111: [: =: unary operator expected cat: /proc/sys/dev/parport/p*/dma: No such file or directory ./ppdiag: line 116: [: =: unary operator expected cat: /proc/sys/dev/parport/p*/base-addr: No such file or directory S02: p*: cat: /proc/sys/dev/parport/p*/modes: No such file or directory S02: modes: S02: ADDR : S02: IRQ : S02: DMA : grep: /etc/modules.conf: No such file or directory S03: no parport parameters S10: ppdev built as module ./ppdiag: line 240: [: too many arguments S12: ERROR /dev/p* does not exist! successfull end .... ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
