I got measurement for EDM generator voltage an current into linuxcnc but do now where to put them.
User interface need to be modified. As is now there is now in motion module there is motion.spindle while motion.edm is needed, any ideas? On Mon, 9 May 2016 11:49:06 +0800 Thomas Powderly <[email protected]> wrote: > Hello Nicklas > yes the halcmds are but not the Mcodes > also you need python ( any version ) > and for python, 2 libraries 'sys' and 'subprocess' > PeteG is working on WEDM with paths ( not linuxcnc ) > i am working on sinkEDM using linuxcnc to 'pose' the tool and HAL to cut > good to hear from you > tomp tjtr33 > > On 05/08/16 23:51, Nicklas Karlsson wrote: > > Just had to finnish stepper decimal point first and should continue with my > > EDM now. Are the halcmd commands used in your files already part of > > linuxcnc? > > > > On Sun, 8 May 2016 19:11:31 +0800 > > Thomas Powderly <[email protected]> wrote: > > > >> here ya go > >> 1st install of PD EDM technology > >> OpenEDM.org ;-) > >> tomp tjtr33 > >> > >> lemme know what, if any, makes sense > >> > >> pete I cc'd Seb K of linuxcnc > >> and nicklas karlsson ------------------------------------------------------------------------------ Mobile security can be enabling, not merely restricting. Employees who bring their own devices (BYOD) to work are irked by the imposition of MDM restrictions. Mobile Device Manager Plus allows you to control only the apps on BYO-devices by containerizing them, leaving personal data untouched! https://ad.doubleclick.net/ddm/clk/304595813;131938128;j _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
