On Sat, 14 May 2016 23:40:48 +0800 Thomas Powderly <[email protected]> wrote:
> nicklas, i use no spindle in sink edm That't the point. "Cutting" tools I could come up with are: spindle, turning, EDM, laser cutter, water jet, plasma thorch, 3D printing and I have even seen sewing on this forum. Motion module have same signals but tool varies. It would make sense with possibility to change the motion.spindle module according to tool used just as it make sense for kinematics. > ... > i use mcodes a lot to set edm parameters in generators > (i sent you some examples, tho i do not know your hardware) I will use this m-codes. Should just put generator in real machine and get parameters for gap control correct. > > in general, edm hole drilling abd edgrinding use rotating tools > wedm does not > sink edm does not ( generally ) > > wedm often uses cutter comp > sink edm uses 'orbiting', a way to make the tool effectively larger > orbiting is 'like' cutter comp but is around a centre, not off to one > side of a path vector > > ( this motion accomodates the reduced overcut of lower power, > which creates a larger cavity with a finer finish, > with the 'disadvantage of larger outside corner radii [larger by a some > microns]) > > orbiting relies on retracting/backingup, so is outside the normal motion > fo linuxcnc > > hth > tomp ------------------------------------------------------------------------------ Mobile security can be enabling, not merely restricting. Employees who bring their own devices (BYOD) to work are irked by the imposition of MDM restrictions. Mobile Device Manager Plus allows you to control only the apps on BYO-devices by containerizing them, leaving personal data untouched! https://ad.doubleclick.net/ddm/clk/304595813;131938128;j _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
