On Saturday 14 May 2016 18:44:54 John Thornton wrote: > Looks like a decent little lathe. Spindle speed is a bit low for that > size lathe , my old Taiwan Samson 16x48 gap bed will do 2020 in high > high. Bet you don't have any of the problems you have with the toy > lathe. The chuck sounds like a D series chuck with is good. My Samson > uses D1-6 I think > http://www.grizzly.com/products/10-D1-6-3-Jaw-Chuck/T10402?utm_campaig >n=zPage yours is maybe a D1-4 > http://www.grizzly.com/products/8-D1-4-3-Jaw-Chuck/T10398?utm_campaign >=zPage > > Off to make some jerky! > You are dreaming John, it has 3, maybe 6mm studs screwed into the back of the chuck, which fit thru matching holes in the spindles flange & you have to putz around 20 minutes a nut to get the nut started straight, because theres not any real room between the flange and the spindle housing for fingers. I doubt the TIR of the 3 jaw is under 10 thou too. But I think its moot as I have a rebuilt Sheldon 13x40 to go look at in another few days.
Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> ------------------------------------------------------------------------------ Mobile security can be enabling, not merely restricting. Employees who bring their own devices (BYOD) to work are irked by the imposition of MDM restrictions. Mobile Device Manager Plus allows you to control only the apps on BYO-devices by containerizing them, leaving personal data untouched! https://ad.doubleclick.net/ddm/clk/304595813;131938128;j _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
